INFLUENCE OF LASER PARAMETERS ON THE PROCESSING OF ACRYLIC

Authors

  • Pāvels Ščetiļnikovs Rezekne Academy of Technologies
  • Imants Adijāns Rezekne Academy of Technologies

DOI:

https://doi.org/10.17770/het2021.25.6800

Keywords:

Acrylic, CO2 laser, Laser cutting, Laser engraving, Laser processing of acrylic

Abstract

The publication describes the obtained results of the depth and width of the engraving line and cutting line when processing materials such as acrylic. In the experiment, we used a SUNTOP ST-CC9060 CO2 laser and an OLYMPUS OLS5000 laser microscope. The aim of the experiment was to find parameters for optimal cutting and many parameters for different engraving depths.

Downloads

Download data is not yet available.

References

Downloads

Published

2021-04-23

Issue

Section

Mechatronics, production technologies and environmental protection