RESEARCH OF POSSIBILITIES OF LASER POLISHING OF THE SURFACE OF ALUMINUM

Authors

  • Kevins Bulavskis Rezekne Academy of Technologies
  • Imants Adijāns Rezekne Academy of Technologies
  • Lyubomir Lazov Rezekne Academy of Technologies

DOI:

https://doi.org/10.17770/het2021.25.6794

Keywords:

aluminum laser processing, fiber laser, laser polishing, surface roughness

Abstract

The report considers the possibility of reducing the roughness after laser polishing of Aluminum plates. A CHANXAN CX-20G fiber laser with a wavelength of 1064 nm is used for the research. As a result of the experiment, 4 matrices were marked with a fiber laser on 3 samples for each series of the experiment. Then, using a multifunctional microscope, the roughness of the treated and untreated aluminum surface was measured. At the end of the research, conclusions were made about the changes in roughness in the course of this experiment.

Downloads

Download data is not yet available.

References

Методы исследования и контроля шероховатости поверхности металлов и сплавов Ю.Ф. Назаров*, А.М. Шкилько, В.В. Тихоненко, И.В. Компанеец

Surface roughness analysis after laser assisted machining of hard to cut materials, D Przestacki1 , M Jankowiak

Studying the Effect of Cutting Conditions in Turning Process on Surface Roughness for Different Materials, D. K. Suker, M. S. Alsoufi, M. M. Alhusaini, S. A. Azam

Исследование параметров шероховатости поверхностного слоя и точности изготовления изделий аддитивного производства* Д.И. Сухов, С.В. Неруш, С.В. Беляков, П.Б. Мазало

Уменьшение шереховатости ситалловой подложки до наноразмерныыых значений, В.В. Бесогонов, И.Н. Скворцова.

АДДИТИВНЫЕ ТЕХНОЛОГИИ И ЛАЗЕРНАЯ ПОВЕРХНОСТНАЯ ОБРАБОТКА КАК АЛЬТЕРНАТИВА КЛАССИЧЕСКИМ МЕТОДАМ ПРОИЗВОДСТВА И ОБРАБОТКИ ДЕТАЛЕЙ, Шальнова С.А.1 Санкт-Петербургский политехнический университет Петра Великого, г. Санкт-Петербург

Ti surface laser polishing: effect of laser path and assist gas, L.Giorleoa *, E. Cerettia , C. Giardinib

LASER POLISHING OF ADDITIVE LASER MANUFACTURING SURFACES Benoit ROSA, Pascal MOGNOL and Jean Yves HASCOET

Using the Olympus OLS5000 Laser Confocal Microscope to Measure the Surface Roughness of Printed Circuit Boards (olympus-ims.com)

Алюминий - физические свойства, получение, применение, история:: ТОЧМЕХ (tochmeh.ru)

Физические свойства алюминия зависят от его чистоты (metmk.com.ua)

Downloads

Published

2021-04-23

Issue

Section

Mechatronics, production technologies and environmental protection